Advertisement
M.-Nr. 11313371
A
Install two M10 nuts on each M10 set screw and tighten them so that 15mm ± 1mm of thread protrudes; see Fig. 3.
A
Install the M10 set screws with the 15mm-long side in place of the machine feet and screw them in as far as they will
go; see Fig. 3.
A
Install a B10.5 washer on each set screw.
A
Lift the washing machine onto the stand, pushing the set screws into the stand.
A
From inside the stand, install one B10.5 washer and one M10 nut on each set screw and tighten; see Fig. 3.
Installing a dryer on the stand
A
Unscrew the dryer feet by at least 5mm.
A
Place the dryer on the stand and slide its rear feet into the clamping plates.
A
Level the dryer on the stand.
A
Screw one M6x20 screw (1) into each of the clamping plates and tighten; see Fig. 4.
Installing the stand panels
A
Use four M4 x 25 screws to attach each of the two side panels; see Fig. 5.
A
Use four M4 x 25 screws to attach the front panel; see Fig. 5.
en-US
es
Instrucciones de montaje APCL zócalo 47/75
Motivo: Con el zócalo se consigue una altura de trabajo más ergonómica para la lavadora o la secadora.
APCL007, APCL011 (zócalo 47 cm)
Piezas del suministro
Número Nº de mat.
Denominación
1
Zócalo
4
Taco S12
8
Arandela B15 x 44 x 3
4
Arandela 8,4
4
Tornillo hexagonal para madera 8 x 65
4
Tornillo prisionero M10 x 50
12
Tuerca hexagonal M10
8
Arandela B10,5
8
Placa
2
Placa tensora
4
Tornillo alomado CEM 6 x 12
2
Tornillo hexagonal M6 x 20
1
Pared frontal (solo zócalo cerrado)
2
Pared lateral (solo zócalo cerrado)
12
Tornillo alomado M4 x 25 (solo zócalo cerrado)
Diese Unterlagen dürfen ohne unsere Genehmigung weder vervielfältigt noch Dritten zugänglich gemacht werden. Eigentumsrechte vorbehalten.
Umbau- und Montageanweisung
21 von 61
16.07.2020
Advertisement
