Troubleshooting - Whirlpool 900 Series Use And Care Manual

Whirlpool 900 series dishwashers use & care guide
Hide thumbs Also See for 900 Series:
Table of Contents

Advertisement

Troubleshooting
Before calling
for assistance
please check the chart below for problems you can fix. It could
save you the cost of a service call.
Dishwasher
problems
PROBLEM
Dishwasher
does
not run or stops
during
a cycle
CHECK THE FOLLOWING
Is the door tightly closed and securely latched?
Has the cycle been set correctly? See pages 5 and 12-l 3.
Has a household fuse or circuit breaker blown or tripped?
If the motor stopped because of an overload, it will automatically
reset itself within a few minutes. If it does not start, call for service.
Is the water supply turned on?
Dishwasher
runs too long
Dishwasher
will not fill
Water remains
in dishwasher
Is the dishwasher wired into a live circuit with the proper voltage?
Cycle times depend on the temperature
of the water entering the
dishwasher.
Cooler water results in longer cycle times.
Undercounter
dishwashers
require adequate enclosure for proper
operation. See Installation
Instructions
for complete information.
Is Overfill Protector stuck in "up" position? Overfill Protector should
move up and down freely. Press down to release. See page 16.
Allow cycle to finish. A small amount of water remaining is normal.
Check the drain air gap (if installed). If it is clogged, follow the
manufacturer's
cleaning instructions.
Detergent
remains
Has the cycle completed?
in covered
section
of dispenser
Is the detergent fresh and dry without lumps? See page 10.
Is the bottom rack in backwards? The rack bumpers must face the
dishwasher
door.
Dishes not as dry
Is the rinse agent dispenser empty? Using a rinse agent greatly
as you expected
improves drying. See page 11.
Do not use AIR DRY option on the next load. See page 13.
Grinding,
grating,
Has a hard object entered the POWER CLEANTM module?
crunching,
or
The sound should stop when the object is ground up.
buzzing
sounds
White residue
Is too much detergent being used? See page 10 for recommended
appears on front
amounts of detergent.
of access panel
Dishwasher
will
not close
Some liquid detergents develop excess foam and residue on panel.
Try a different brand to reduce foaming and eliminate buildup.
Is the bottom rack in backwards? The rack bumpers must face the
dishwasher
door.
21

Advertisement

Table of Contents
loading

Table of Contents