Step 11: Configure The Drive Using Ni Stepper Configuration Utility - National Instruments SMD-7613 Getting Started

If the Drive Status LED does not flash or turn solid green, turn off all power, verify the connections,
and try again. Refer to the
Step 11: Configure the Drive using NI Stepper
Configuration Utility
The NI Stepper Configuration Utility allows the drive to be customised for a specefic motor.
Complete the following steps to customize the motor by using the NI Stepper Configuration
Utility.
1. Visit
ni.com/downloads
2. Install and open the Stepper Configuration Utility on the computer connected to the same
network as the drive.
Figure 12. The NI Stepper Configuration Utility Window
3. Enter the IP address of the drive as configured using the rotary switch in the previous steps
and click Upload from Drive. This will retrieve the model number of the drive you are
using.
12 | ni.com | Getting Started with NI SMD-761x and NI 9512 Modules
Worldwide Support and Services
to download the NI Stepper Configuration Utility.
section for additional tips.