Removing The Power Supply - Siemens SIMATIC Series Operating Instructions Manual
Hide thumbs
Also See for SIMATIC Series:
- Manual (118 pages) ,
- Getting started (46 pages) ,
- Product information (12 pages)
Table of Contents
Advertisement
Device maintenance and repair
7.4 Removing and installing hardware
7.4.3
Removing the power supply
Requirement
● The device is fully disconnected from the mains voltage, see section "Switching off the
device (Page 63)".
● The device is open, see the section "Open the device (Page 76)".
● T10 screwdriver
● Diagonal cutter
Procedure
1. Disconnect the cables from the drives and the motherboard.
2. Remove the cable ties securing the power cables in the enclosure.
3. Remove the four fixing screws that are marked in the figure below.
4. Pull the power supply upward and out of the housing.
118
Operating Instructions, 04/2020, A5E49948632-AA
SIMATIC IPC547G
- Quick Links:
- Product Description
Hide quick links:
Advertisement
Table of Contents
Need help?
Do you have a question about the SIMATIC Series and is the answer not in the manual?
Questions and answers