Summary of Contents for weinor Sottezza II Stretch
Page 1
Important details for the end consumer. Please read these instructions and observe their content and warnings before using the equipment for the first time. Sottezza II Stretch/ LED / Sottezza II OptiStretch/ LED Maintenance Instructions and Directions for Use Version 4...
6.1 Troubleshooting (by a suitable specialist retailer) ............... 12 7 Conversions or retrofits ..................... 12 8 Disassembly and disposal ..................12 9 Noise level ........................12 Sottezza II Stretch/ LED / Sottezza II OptiStretch/ LED Maintenance Instructions and Directions for Use Version 4 2020-05-06...
Cleaning the sun protection system Clean the aluminium parts. Clean the awning fabric. Sottezza II Stretch/ LED / Sottezza II OptiStretch/ LED Maintenance Instructions and Directions for Use Version 4 2020-05-06 We reserve the right to make technical changes...
If a Sottezza II is used under a roof which is open at the front and the sides, it must therefore be retracted immediately in the event of strong winds (above wind strength 5). Sottezza II Stretch/ LED / Sottezza II OptiStretch/ LED Maintenance Instructions and Directions for Use...
Larger tree branches move, umbrellas are hard to hold, telegraph lines whistle in the wind Wind speed 38-48 km/h = 10.5-13.4 m/s Source: German Met Office (DWD) - Offenbach Sottezza II Stretch/ LED / Sottezza II OptiStretch/ LED Maintenance Instructions and Directions for Use Version 4 2020-05-06...
A motorised sun protection system cannot retract if there is no power. The system must not be used in frosty conditions or if there is a risk of frost. Sottezza II Stretch/ LED / Sottezza II OptiStretch/ LED Maintenance Instructions and Directions for Use...
The Sottezza II is designed to open in order to protect exposed areas from undesired sun. Failure to use the product as intended may result in severe danger. Alterations not envisaged by weinor, such as attaching items or conversions, may only be carried out with the manufacturer's written consent.
/ side channel brackets and the cast parts are made of aluminium. All connecting parts, such as screws, are made of stainless steel. Sottezza II Stretch/ LED / Sottezza II OptiStretch/ LED Maintenance Instructions and Directions for Use...
Clean the aluminium parts at least once a year, and even more often if heavily soiled. To clean, use clean water and add a few drops of pH-neutral or very slightly alkaline detergent. Sottezza II Stretch/ LED / Sottezza II OptiStretch/ LED Maintenance Instructions and Directions for Use...
Our recommendation: Call in a specialist company to carry out the necessary maintenance and care work. Sottezza II Stretch/ LED / Sottezza II OptiStretch/ LED Maintenance Instructions and Directions for Use Version 4...
Preloading tail Lubricating points Rope block Spare parts Only use spare parts approved by weinor. Sottezza II Stretch/ LED / Sottezza II OptiStretch/ LED Maintenance Instructions and Directions for Use Version 4 2020-05-06 We reserve the right to make technical changes...
Noise level When installed, the sun protection system's noise level has been measured at below 70 dB(A). Sottezza II Stretch/ LED / Sottezza II OptiStretch/ LED Maintenance Instructions and Directions for Use Version 4...
Page 13
Mathias-Brüggen-Straße 110 50829 Cologne (Germany) www.weinor.com Hotline: +49(0)221/5 97 09-214 Fax: +49(0)221/5 97 09-898 Sottezza II Stretch/ LED / Sottezza II OptiStretch/ LED Maintenance Instructions and Directions for Use Version 2 2016-09-28 We reserve the right to make technical changes...
Need help?
Do you have a question about the Sottezza II Stretch and is the answer not in the manual?
Questions and answers