Clay Paky SUPER SCAN ZOOM Instruction Manual

INSTRUCTION MANUAL
IMPORTANT: Read carefully. It is essential for the correct and safe use of the
equipment that erectors and operators should be fully conversant with the
information and instructions given in this manual.
1
INSTALLING THE PROJECTOR
• Unpacking
Open the box, remove the projector from the packing and place it on a flat
horizontal surface.
Unpack the standard accessories supplied with the equipment. Inspect the lamp
change label (1) and replace with one of the optional language versions if
necessary.
Make certain that the label is never removed, as it displays important safety
information.
1
• Initial assembly operations
Position the block (2) over the threaded holes on the projector housing, offer
the graduated plate (3) and secure with the eyebolt (4), then fit the knob (5) and
washer (6).
Align the bracket (7) with the plates (3) so as to give the desired height, insert
the bushing (8), the countersunk washer (9) and the screw (10) in the selected
holes and secure with the Allen key supplied.
The bracket (7) can also be fitted from the underside of the projector by revers-
ing the position of the graduated plates (3). If the projector has been shipped
with plate (3) already fitted, before removing the plate (if necessary) remove the
safety bolt located inside the fixture in correspondence with eyebolt (4).
Adjust the bracket to the desired angle and secure by tightening the knobs (5).
Fix the safety wire (11) of the lamp access cover (12) to the graduated plate (3).
Fit the four side handles (13) with the screws (14) provided.
7
12
15
11
• Fitting the lamp
Refer to directions for replacement of the lamp given under heading 6 MAINTE-
NANCE.
SUPER SCAN ZOOM
6
4 5
2 3
8
14
9 10 13
3
• Removal of transit bands
Loosen the knob (15) and remove the lamp
access cover (12) from the projector.
Locate and remove all elastic transit bands
(16) from the colour, frost, prism and
zoom/focus lens drives.
Replace the cover and tighten the knob.
• Installing the projector
The projector can be mounted any position without its operating characteristics being
affected.
IMPORTANT: fix the projector in the desired position utilizing the holes in the
bracket (7). Secure preferably using two ø12 bolts with nuts and lock washers.
Make certain that the anchorage is stable before positioning the projector.
• Fitting the safety wire
The projector must never be erected without the safety wire (17). The wire is
secured to the gantry or other structure, then anchored to the eye bolts (4) on the
projector itself.
IMPORTANT: the safety wire must be secured to the projector and to the supporting
structure in such a way that if the bracket should fail, the projector will fall as short a
distance as possible. Following any such failure, the safety wire must be replaced
with a genuine Clay Paky spare.
• Minimum distance from target objects
The projector must be positioned in such a way
that objects struck by the beam are located at least
2.5 m (8' 2") from the lens.
• Minimum distance of inflammable materials from any part of the equipment:
0.10 m (4").
The appliance may be mounted on surfaces rated normally inflammable.
IMPORTANT: For better and more reliable operation of the projector, the ambient tem-
perature must not exceed 35° C (95° F). Protection factor IP 20: the appliance is pro-
tected against penetration of solid bodies more than 12mm (0.5") in diameter (first digit
2), but can be damaged by spray, jet, drip or rain water (second digit 0).
HMI 1200
15
16
17
4
(8' 2")
2.5 m
HMI 1200
9