Maintenance; Greasing The Attachment; Checking The Hydraulic Lines - Toro Skeleton Grapple TXL 2000 Operator's Manual

Maintenance

Determine the left and right sides of the machine from
the normal operating position.
CAUTION
If you leave the key in the switch, someone
could accidently start the engine and
seriously injure you or other bystanders.
Remove the key from the switch before you
perform any maintenance.

Greasing the Attachment

Service Interval: Before each use or daily (and
immediately after every washing).
Grease Type: General-purpose grease.
1. Park the machine on a level surface, lower the
loader arms, and close the grapple jaws.
2. Shut off the engine and remove the key.
3. Clean the grease fittings with a rag.
4. Connect a grease gun to each fitting
5. Pump grease into the fittings until grease begins
to ooze out of the bearings (approximately 3
pumps).
6. Wipe up any excess grease.
(Figure
Figure 7
Checking the Hydraulic
Lines
Service Interval: Before each use or daily
WARNING
Hydraulic fluid escaping under pressure can
penetrate skin and cause injury. Fluid injected
into the skin must be surgically removed
within a few hours by a doctor familiar with
this form of injury; otherwise, gangrene may
result.
• Keep your body and hands away from
pinhole leaks or nozzles that eject
high-pressure hydraulic fluid.
• Use cardboard or paper to find hydraulic
leaks; never use your hands.
7).
g270552
8