Table of Contents
Advertisement
LTC 8900 Series
Caution!
Important considerations related to the LTC 8943/95 System Controller PC:
This PC contains a solid state hard drive with limited storage capacity. Please refrain from
installing additional software that would reduce the remaining hard drive capacity to less than
1GB.
No anti-virus software is provided. If this PC will be connected to a network or the internet,
Bosch strongly recommends that a user-supplied anti-virus software package is installed to
provide protection.
In the inadvertent chance that a catastrophic problem or other unforeseen act corrupts the
!
operating system files, a "Recovery DVD" is provided. The DVD can be used to restore the
PC's hard drive back to its original Factory default image. Complete instruction for use can be
found on the DVD label.
A CD/DVD reader/writer is installed in this PC. Windows XP supports reading CD/DVDs and
writing to CDs. If desired, the supplied copy of NERO CD/DVD media software can be
installed an used to write to DVDs.
The latest version of Allegiant LTC 8059 Master Control Software (MCS) is installed on this
PC. Older versions are included (but not installed) to support backward compatibility with
older Allegiant CPU firmware. If necessary, refer to the Allegiant MCS desktop folder for
additional information related to using the older MCS versions.
6.4.2
PC Monitor Installation
The monitor (UML-191-90) is a 48.3 cm (19 in.) LCD flat panel monitor that accommodates
both video and PC input simultaneously. To install the monitor into an EIA 19 in. rack, attach
the monitor to the monitor rack kit (UMM-LCDUB-RM) following the instructions supplied with
the monitor rack kit. Connect the supplied VGA cable to the PC. If desired, an available
monitor output from the Allegiant (or other composite video source) can be connected to the
video input using a coax with BNC connector. Attach AC line cord but do not attach line cord
to AC power source until instructed.
6.4.3
Keyboard/Mouse Rack Installation
The Keyboard/Mouse rack tray is designed to be installed into an EIA 19 in. rack, but a rack
having a shallow depth may require additional work. If the tray does not match up with the
rear part of the rack (too short or too long), some custom provisions at time of installation will
be needed. In some cases, the back portion of the tray may protrude from the rear of the rack.
Be sure to provide support for the rear portion of the tray unit.
6.4.4
Final Installation
Attach the mouse, keyboard, and software security dongle to the appropriate ports. These
connection points are illustrated in , page 66. If desired, the USB and PS2 ports located on
the front of the PC can also be used for external accessory connections.
6.5
LTC 8902 Series Output Bay and LTC 8903 Series Input Bay
Installation
The LTC 8902 Series and LTC 8903 Series bays require insertion of the power supply, data
receiver module, and the video modules. Remove the front panel of the bay (LTC 8902 Series
or LTC 8903 Series) by loosening the four (4) corner fasteners.
LTC 8902 Series Video Output bays are supplied with LTC 8906 Series Power Supplies.
LTC 8903 Series Video Input bays are supplied with LTC 8805 Series Power Supplies.
Bosch Security Systems, Inc.
Hardware Installation Procedure for Redundant System Configuration Utilizing LTC 8901
Installation Manual
39
Series CPU | en
2015.01 | 10.6 |
Hide quick links:
Advertisement
Table of Contents
