Inserting The Remote Control Batteries - SYMA X500 Instructions For Use Manual

Attaching the phone holder
1
2
Inserting the remote
control batteries
* When installing the batteries, ensure that you match the + and – ends
of the battery with the + and – signs on the controller.
!
* During the battery installation, it must be ensured that the polarities
of the batteries are matched with that of the battery box. No battery
shall be installed with the opposite polarity.
* Please do not use new and old batteries together.
* Please do not use different types of batteries together.
* Do not use rechargeable batteries.
Flight preparation and turning the aircraft on/off
Pairing the remote control with the aircraft
3
4
1
Remote control
indicator flashes
rapidly
* When you switch on the remote control, the indicator will flash
rapidly for approximately 20 secs to indicate that the remote
!
control is waiting for a signal. The indicator will then flash slowly to
indicate that pairing mode has been disabled.
Open the remote control
1
Close the remote control
2
1
Switch off the remote controller
during charging
Charging : red light is on
Finish charging: light is off
5V 1-2A
Switch on the remote
control Indicator flashes
rapidly -> slowly
Indicator stays constant when
pairing is complete.
-6-
2 2
2
English
1