SYMA X5C User Manual

CAUTIONS WHEN CHARGING

1.When charging, please put this product on a dried or ventilated area and keep
it far away from heat source or explosive product.
2.When charging, please remove the batteries from the quadcopter. Then
charging process should be supervised by an adult so as not to cause an
accident.
3.After flying, please do not charge the battery if the surface temperature is still
not cool. Otherwise it may cause a swollen battery or even a fire hazard.
4.Please make sure that you use the original USB charging cable provided.When
the battery has been used for a long time, or appears to be swollen, please
replace them.
5.A battery when not in use for a long time will lose its charge automatically.
Charging or discharging too often may reduce the life of the battery.
BATTERY REPAIR & MAINTENANCE
1.Battery should be put in the dried or ventilated place with enviroment
temperature about 18-25℃.
2.In order to enhance the using life of the battery, please avoid repeat charging
or excessive discharging.
3.When the battery needs to be stored for a long time,please charge the battery
first.That is to say, charge the battery for about 50-60% of the volume and then
well store it.
4.If you do not use it for more than 1 months, it's highly recommended that you
need to check the battery voltage every month so as to make sure the voltage
no less than 3V. Otherwise please do by following No.(3) mentioned.
INSTALL LANDING SKIDS & BLDAE PROTECTING FRAME
1.Install the landing skids to the bottom of quadcopter (Figure 1).
2.Install the blade protecting frame to every corner than lock screws (Figure 2).
CONTROLLER MODES & INSTRUCTIONS
The transmitter built-in two modes, Mode 1 & Mode 2, in
line with different customer's usage pattern. Keep pushing
button B to right, than turn on the transmitter power to
change Mode 1 or Mode 2.
Figure.1 Figure.2
-5-
B