Step 1A: Configure Vlans; Step 1B: Configure Network Interfaces - NEC SV9100 Configuration Note

Configuration Note
4.1.1

Step 1a: Configure VLANs

This step describes how to define VLANs for each of the following interfaces:

LAN VoIP (assigned the name "Voice")

WAN VoIP (assigned the name "WANSP")

To configure the VLANs:
1. Open the Ethernet Device Table page (Configuration tab > VoIP menu > Network >
Ethernet Device Table).
2. There will be one existing row for VLAN ID 1 and underlying interface GROUP_1.
3. Add another VLAN ID 2 for the WAN side as follows:
Index
VLAN ID
Underlying Interface
Name
Tagging
Figure 4-2: Configured VLAN IDs in Ethernet Device Table
4.1.2

Step 1b: Configure Network Interfaces

This step describes how to configure the IP network interfaces for each of the following
interfaces:

LAN VoIP (assigned the name "Voice")

WAN VoIP (assigned the name "WANSP")

To configure the IP network interfaces:
1. Open the IP Interfaces Table page (Configuration tab > VoIP menu > Network > IP
Interfaces Table).
2. Modify the existing LAN network interface:
Version 7.0
Parameter
25
4. Configuring AudioCodes E-SBC
Value
1
2
GROUP_2 (Ethernet port group)
vlan 2
Untagged
AudioCodes Mediant E-SBC