Parksense Rear Park Assist System - If Equipped; Parksense Sensors; Parksense Warning Display; Parksense Display - Jeep Compass 2021 Owner's Manual

116 STARTING AND OPERATING
Stationary Objects And Vehicles
ACC does not react to stationary objects and
stationary vehicles. For example, ACC will not
react in situations where the vehicle you are
following exits your lane and the vehicle ahead
is stopped in your lane. Always be attentive and
ready to apply the brakes if necessary.
Stationary Object And Stationary Vehicle Example
PARKSENSE REAR PARK ASSIST SYSTEM —
IF EQUIPPED
The ParkSense Rear Park Assist system provides
visual and audible indications of the distance
between the rear fascia and a detected obstacle
when backing up (e.g. during a parking
maneuver). For limitations of this system and
recommendations see, Ú page 119.
ParkSense will retain the last system state
(enabled or disabled) from the last ignition cycle
when the ignition is changed to the ON/RUN
position.
ParkSense can be active only when the gear
selector is in REVERSE. The system will remain
active until the vehicle speed is increased to
approximately 7 mph (11 km/h) or above. While
in REVERSE and above the system's operating
speed, a warning will appear in the instrument
cluster display indicating the vehicle speed is too
fast. The system will become active again if the
vehicle speed is decreased to speeds less than
approximately 6 mph (9 km/h).
P S S
ARK ENSE ENSORS
The four ParkSense sensors, located in the rear
fascia/bumper, monitor the area behind the
vehicle that is within the sensors' field of view.
The sensors can detect obstacles from
approximately 12 inches (30 cm) up to
79 inches (200 cm) from the rear fascia/
bumper in the horizontal direction, depending
on the location, type and orientation of the
obstacle.
P S W D
ARK ENSE ARNING ISPLAY
The ParkSense Warning screen will only be
displayed if "Sound and Display" is selected
from the Customer - Programmable Features
section of the Uconnect system Ú page 139.
The ParkSense Warning screen is located within
the instrument cluster display Ú page 68. It
provides visual warnings to indicate the
distance between the rear fascia/bumper and
the detected obstacle.
P S D
ARK ENSE ISPLAY
When the vehicle is in REVERSE, the instrument
cluster display will show the park assist system
status.
The system will indicate a detected obstacle by
showing a single arc in one or more regions
based on the obstacle's distance and location
relative to the vehicle.
If an obstacle is detected in the center rear
region, the display will show a single solid arc in
the center rear region. As the vehicle moves
closer to the obstacle, the display will show the
single arc moving closer to the vehicle and the
audible chime increases as the objects get
close to the vehicle.