Hyper Top 10A, 12A, 15A - soundsation HYPER TOP Series User Manual

ENGLISH

4.3. Hyper Top 10A, 12A, 15A

1) POWER Switch
Switch up to turn the speaker on, and switch
down to turn it off. Make sure the level con-
trol is down before you turn it on.
2) IEC Socket with Fuse
holder
Plug the line-cord into an AC socket properly
configured for your particular model. In case
of fuse burn, to prevent the risk of fire and
damaging the unit, please use only of the
recommended fuse type as described in the
manual. Before replacing the fuse, make sure
the unit turned off and disconnected from
the AC outlet.
Note: If you happen to loose the AC
line-cord, always use a three-pin plug
with a ground pin.
3) MIC/LINE INPUT Section
There is a female XLR-type connector and
a 1/4" Jack plug that accept a balanced or
unbalanced mic- or line-level signal. The
switch Line/Mic has to be pressed in case of
microphone level signals. There is no phan-
tom power for a microphone, so you should
use a dynamic mic, or use a condenser type if
it has its own battery power.
WARNING: Pressing MIC/LINE switch on line level signals may cause damag-
es to the speaker. Be careful!
4) Aux In
This is a 1/8" mini jack plug that accept an unbalanced stereo line-level signal. This
auxiliary input is directly routed to EQ and master Level controls.
WARNING: Turn the LEVEL (control n. 8) down (counterclockwise) before
connecting any source, especially if you're using the LINE OUT connection. If
not, you could be in for a startling surprise and this may cause a damage to
the unit and to your hearing.
5) Level 1
This controls the overall signal level at the Mic-Line inputs.
12
Hyper TOP series User manual
aux in
4
in
3
mic in
mic/line in
HYPER TOP 15A
2
5 6 7 8
high low level
level 1 level 2
on
limit
0 10 0 10 -10 +10 -10 +10 0 10
LINE
MIC
stereo
line in line out
line in
line in master
signal flow
Power
ON
OFF
AC INPUT
AC 230V 50HZ
T2.0AL/250V
9
10
11
12
1