Table of Contents
Advertisement
Hints and Tips
If a problem does occur, it may often be due to something very minor. The following table
contains various tips. If you require additional assistance
For UK, please call our UK Call Centre on 0344 561 1234.
•
For Ireland, please call our Ireland Call Center on 1 890 818 575.
•
General
Problem
No power.
The remote control is
not function.
No sound from the unit.
The unit does not
respond when pressing
any buttons.
CD
Problem
Disc in place but the unit
won't play.
Disc skips
Solution
• Ensure the mains plug is connected.
• Make sure that you select the ON mode.
• Use the remote control near the unit.
• Point the remote control at the remote sensor on the unit.
• Replace the battery in the remote control with a new one.
• Remove any obstacles between the remote control and
the unit.
Please try either one of the solutions below:
• Make sure that the unit is not muted. Press the
VOL + / – on the remote control, or turn the – VOLUME +
dial on the unit to resume normal listening.
• Press
on the unit or on the remote control to switch
the unit to standby mode. Then press the button again to
switch the unit on.
• Unplug the unit from the mains socket, then plug them
again. Switch on the unit.
• The unit may freeze up during use. Switch the unit off and
then on again at the mains socket to reset the unit.
Solution
•
Make sure you've selected CD mode.
•
Make sure the disc label is facing up.
•
Make sure the disc is clean.
PAUSE mode may be activated, deactivate it.
•
•
Disc may be damaged or dirty; check and clean the disc.
•
Make sure the unit is on a secure spot. Vibrations or
jarring can cause the disc to skip.
or the
31
Hide quick links:
Advertisement
Table of Contents
Need help?
Do you have a question about the UX-D750 and is the answer not in the manual?
Questions and answers
mains power not applying
The JVC UX-D750 unit does not power up, showing no red light and no response to the power button, despite the mains fuse being fine. Possible reasons could include:
1. The mains plug is not fully inserted into the mains socket.
2. A faulty power connection or internal power supply failure.
3. The unit is in standby mode but not responding.
4. A deeper hardware issue requiring professional repair.
A free estimate and repair service is available for this issue.
This answer is automatically generated
The stereo keeps saying Goodbye and shutting down even though it's in use. Also, I changed the clock and it’s not changing the time.
The JVC UX-D750 stereo may say "BYE BYE" and shut down while in use because it automatically enters ECOPOWER / STANDBY mode after 15 minutes of inactivity in BT, AUX 1, AUX 2, DISC, or USB mode, or if the external device is disconnected, turned off, or the volume is too low.
The clock may not be changing the time because the RDS CLOCK system does not work properly in areas where RDS CLOCK service is unavailable.
This answer is automatically generated