Kenwood DNX8160DABS Quick Start Manual page 27

Installation
Ñ Connecting wires to terminals
Fuse (15A)
Accessory 1
Light Blue/Yellow
(Steering remote control wire)
REMOTE CONT
Blue/White
(Power control/ Antenna control wire)
Brown (Mute control wire)
Purple/White (Reverse sensor wire)
Light Green (Parking sensor wire)
PRK SW
For best safety, be sure to connect
the parking sensor.
A B C
If no connections are made, do not let the cable
come out from the tab.
To steering remote
STEERING WHEEL
To use the steering wheel remote control feature, you need an
REMOTE INPUT
exclusive remote adapter (not supplied) matched to your car.
Connect either to the power control terminal when using
P. CONT ANT CONT
the optional power amplifier, or to the power terminal for the
booster amplifier of the film-type or short pole type antenna.
(Max. 300mA, 12V)
DNX8160DABS/ DNX716WDABS/ DNX5160DABS/
DNX516DABS/ DNX5160BTS
MUTE Connect to the terminal that is grounded when either the
telephone rings or during conversation.
DNX3160BT : Not used
Connect to vehicle's reverse lamp harness when using the
optional rear view camera.
REVERSE
Connect to the vehicle's parking
brake detection switch harness.
A: Black (Ground wire)
B: Yellow (Battery wire)
C: Red (Ignition wire)
8 6 4 2
7 5 3 1
8 6 4 2
7 5 3 1
Ñ Wiring harness (Accessory 1) connector
function guide
Pin Color and function
A-4 Yellow Battery
A-5 Blue/White Power Control
A-6 Orange/White Dimmer
A-7 Red Ignition (ACC)
A-8 Black Earth (Ground) Connection
B-1/ B-2 Purple (+) / Purple/Black (–)
B-3/ B-4 Gray (+) / Gray/Black (–)
B-5/ B-6 White (+) / White/Black (–)
B-7/ B-8 Green (+) / Green/Black (–)
• *Speaker Impedance: 4-8 Ω
#WARNING for Connecting the ISO Connector
The pin arrangement for the ISO connectors depends on
the type of vehicle you drive. Make sure to make the proper
connections to prevent damage to the unit. The default
connection for the wiring harness is described in (1) below.
If the ISO connector pins are set as described in (2), make
the connection as illustrated. Please be sure to reconnect
the cable as shown (2) below to install this unit to the
Volkswagen vehicles etc.
(1): Default setting
The red (A-7 pin) of the vehicle's ISO connector is linked with
the ignition, and the yellow (A-4 pin) is connected to the
constant power supply.
Red (Ignition cable) Red (A-7 pin)
Unit Vehicle
Yellow (Battery cable) Yellow (A-4 pin)
(2)
The red (A-7 pin) of the vehicle's ISO connector is connected
to the constant power supply, and the yellow (A-4 pin) is
linked to the ignition.
Red (Ignition cable) Red (A-7 pin)
Unit Vehicle
Yellow (Battery cable) Yellow (A-4 pin)
Rear Right
Front Right
Front Left
Rear Left
English | 27