Toro RP-1200D Operator's Manual page 4

– Never refuel or drain the machine indoors.
•
Check that the operator's presence controls, safety
switches, and shields are attached and functioning
properly. Do not operate unless they are functioning
properly.
Operation
•
Never run an engine in an enclosed area.
•
Only operate in good light, keeping away from holes and
hidden hazards.
•
Do not operate in standing water.
•
Ensure that the area is clear of other people before
operating the machine. Stop the machine if anyone enters
the area.
•
Keep pets and bystanders away.
•
Keep feet clear of the plate compactor.
•
Ear protection is required when operating this equipment.
•
Do not operate the machine under the influence of
alcohol or drugs.
•
For foot protection, wear steel toe shoes or toe pads.
•
Never operate with the guards not securely in place. Be
sure all interlocks are attached, adjusted properly, and
functioning property.
•
Do not change the engine governor setting or overspeed
the engine.
•
Use care when loading or unloading the machine into a
trailer or truck.
•
Never leave the machine running unattended. Always
set the throttle to slow, stop the engine, and wait for all
moving parts to stop before leaving.
•
Do not touch parts which may be hot from operation.
Allow them to cool before attempting to maintain, adjust,
or service.
•
Before compacting soil, have the area marked for
underground utilities.
•
Lightning can cause severe injury or death. If lightning
is seen or thunder is heard in the area, do not operate
the machine; seek shelter.
Maintenance and Storage
•
Park the machine on a level surface, set the throttle to
slow, and stop the engine. Wait for all movement to stop
before adjusting, cleaning, or repairing.
•
Clean debris from the drives, mufflers, and engine to help
prevent fires. Clean up fuel and oil spillage.
•
Let the engine cool before storing and do not store near
flame.
•
Do not store fuel near flames or drain indoors.
•
Park the machine on level ground. Never allow untrained
personnel to service the machine.
•
Carefully release pressure from components with stored
energy.
•
Keep hands and feet away from moving parts. If possible,
do not make adjustments with the engine running.
•
Keep all parts in good working condition and all hardware
tightened. Replace all worn or damaged decals.
•
Keep nuts and bolts tight. Keep equipment in good
condition.
•
Keep the machine free from the build-up of mud, rocks,
or other debris. Clean up oil or fuel spillage. Allow the
machine to cool before storing.
•
Use extra care when handling fuels. They are flammable
and vapors are explosive.
– Use only an approved container.
– Never remove the fuel cap or add fuel when the
engine is running. Allow the engine to cool before
refueling. Do not smoke.
– Never refuel the machine indoors.
– Never store the machine or fuel container inside
where there is an open flame, such as near a water
heater or furnace.
– Never fill a fuel container while it is inside a vehicle,
trunk, pick-up bed, or any surface other than the
ground.
– Keep container nozzle in contact with the tank during
filling.
•
Stop and inspect the equipment if you strike an object.
Make any necessary repairs before restarting.
•
To best protect your investment and maintain optimal
performance of your Toro equipment, count on Toro
genuine parts. When it comes to reliability, Toro delivers
replacement parts designed to the exact engineering
specifications of our equipment. For peace of mind, insist
on Toro genuine parts.
4