Advertisement
4
Installing the Power Plug
Assembly
Parts needed for this procedure:
1
Power plug assembly
Procedure
1. On the dashboard, from the operator's position,
measure 2-7/8 inches to the right of the center of the
key hole and 1-1/4 inch from the bottom edge of the
switch cluster (Figure 4). Mark the dash at that point.
1. Keyhole
2. Switch cluster
2. Drill a 7/8 inch diameter hole at the mark in the
dash (Figure 4).
3. Locate the power plug assembly in loose parts.
Unscrew the assembly as shown in Figure 5.
1. Power plug outer casing
2. Plastic plug
4. Install the power plug interior and plastic cap
through the dash in the hole previously drilled
(Figure 6).
Figure 4
3. Mark here, drill at center
point
Figure 5
3. Power plug interior
1. Dash underside
2. Power plug interior
5. Behind the dash, secure the power plug by installing
the power plug outer casing over the power plug
interior installed in the dash previously (Figure 6).
3
Figure 6
3. Power plug outer casing
Advertisement
