Toro 07318 Installation Instructions Manual

12V Power Plug Adapter Kit
Workman
Model No. 07318—Serial No. 310000001 and Up
Installation
Loose Parts
Use the chart below to verify that all parts have been shipped.
Procedure
1
2
3
4
5
1
Preparing the Machine
No Parts Required
Procedure
CAUTION
Batteries can give you a powerful electrical shock.
• Use tools with plastic handles or wrap the
handles of metal tools with electrical tape.
• Be careful not to contact both a positive terminal
and a negative terminal at the same time.
1. Position the vehicle on a level surface, engage the
parking brake and rotate the On/Off key to the Off
position.
2. Raise the bed to access the vehicle batteries. Remove
one of the battery cables linking any two batteries
© 2009—The Toro® Company
8111 Lyndale Avenue South
Bloomington, MN 55420
® MDE Utility Vehicle
Description
No parts required
Converter mount
Converter
Flange bolt (1/4 x 3/4 inch)
Lock nut (1/4 inch)
Fuse assembly
Power plug assembly
Bolt (5/16 x 3/4 inch)
Lock nut (5/16 inch)
Wiring harness
Wire ties
Register at www.Toro.com.
Qty.
–
Prepare the machine.
1
1
Assemble the converter.
4
4
Install the fuse assembly and electric
1
mount plate.
1 Install the power plug assembly.
2
2
Mount the converter.
1
4
in the bank to remove power from the system
(Figure 1).
1. Battery link cable
3. Open the front hood to gain access to front end of
the machine.
Form No. 3363-440 Rev A
Installation Instructions
Use
Figure 1
Original Instructions (EN)
Printed in the USA.
All Rights Reserved