Table of Contents
Advertisement
2-1 Main Unit
1 HDD (hard disk drive) indicator (amber)
Lights in amber when data is being accessed on the
system hard disk contained in the Main Unit.
2 STANDBY/ON switch
Press to power the Main Unit on.
For power off operation, see page 3-10.
Note
You can power the Main Unit off by pressing and
holding this switch for 4 seconds or more. However, to
power the Main Unit off, be sure to perform the
procedure on page 3-10 unless otherwise directed by
Sony service representative or unless trouble occurs.
3 Power indicator (green)
Lights in green when the Main Unit has booted
normally.
4 PHONES connector (stereo phone jack) and
LEVEL knob
You can connect headphones to monitor the audio
being edited. Rotate the LEVEL knob to adjust the
audio level.
5 MON (monitor) indicator (green)
This indicator lights and goes out to indicate the
following.
Lit: The AV I/O Block is operating normally.
Flashing: A hardware malfunction has occurred in the
AV I/O Block.
Not lit: The AV I/O Block is in power-saving mode.
6 OPE (operation) indicator (amber)
This indicator is lit when the CPU of the AV I/O Block
is operating.
7 Floppy disk slot
Insert floppy disks here.
8 Floppy disk eject button
Press to eject a floppy disk.
Note
Never eject a floppy disk when the floppy disk active
indicator is lit. Doing so can damage the data on the
floppy disk.
2-2
Chapter 2 Names and Functions of Parts
9 Floppy disk active indicator (green)
Lights in green when the floppy disk drive is accessing
data.
q; Tray open/close button
Press to open or close the disc tray.
qa Disc tray
To load a disc, place it on this tray and then press the
tray open/close button.
qs Active indicator
Lights when the disc drive is accessing the data on a
disc.
qd Tray eject hole
If the disc tray does not open when you press the tray
open/close button, insert a narrow rod into this hole
and press the switch inside.
For details, see Section 3-4-2 "Using Disc Media" (page 3-
12).
Advertisement
Table of Contents
Troubleshooting
