Juniper QFX5120 Series Quick Start Manual page 18

11. Configure the IP address and prefix length for the switch management interface.
[edit]
root@# set interfaces em0 unit 0 family inet address address/prefix-length
NOTE: The management port em0 (labeled MGMT) is located on the front panel of the QFX5120-32C
switch. The management ports em0 (labeled C0) and em1 (labeled C1) are located on the rear panel of the
QFX5120-48Y switch. The management port em0 (labeled MGMT) is located on the rear panel of the
QFX5120-48T switch.
12. (Optional) Configure the static routes to remote prefixes with access to the management port.
[edit]
root@# set routing-options static route remote-prefix next-hop destination-ip retain no-readvertise
13. Enable the Telnet service.
[edit]
root@# set system services telnet
14. Enable the SSH service.
[edit]
root@# set system services SSH
15. Commit the configuration to activate it on the switch.
[edit]
root@# commit
16. Configure in-band management or out-of-band management:
In in-band management, you can configure a network interface or an uplink module (expansion module) interface as
the management interface and connect it to the management device. In this scenario, you can do either of the
following:
Use the automatically created VLAN named default for management of all data interfaces as members of the default
VLAN. Specify the management IP address and the default gateway.
Create a new management VLAN. Specify the VLAN name, VLAN ID, management IP address, and default gateway.
Select the ports that must be part of this VLAN.
In out-of-band management, you use a dedicated management channel (MGMT port) to connect to the management
device. Specify the IP address and gateway of the management interface. Use this IP address to connect to the
switch.
17. (Optional) Specify the SNMP read community, location, and contact to configure SNMP parameters.
18