Starter Removal And Installation - Honda Accord 2008 Manual

07/11/02 09:04:51 61TA0000_040_0012

Starter Removal and Installation

Removal
1. Do the battery removal procedure (see page 22-90).
2. Remove the intake manifold (see page 9-3).
3. Disconnect the starter cable (A) from the B terminal,
and disconnect the BLK/WHT wire (B) from the
solenoid S terminal.
＊０１
4. Remove the harness clamp (C).
5. Remove the two bolts (A) securing the starter, then
remove the starter.
＊０２
A
A
C
Installation
1. Install the starter, then tighten the two bolts.
B
10 x 1.25 mm
45 N·m
(4.5 kgf·m, 33 lbf·ft)
2. Install the harness clamp (A).
A
3. Install the starter cable (B) to the B terminal and the
BLK/WHT wire (C) to the solenoid S terminal. Make
sure the crimped side of the ring terminal faces
away from the starter when you connect it.
ＴＡ０８ＡＥ４Ａ４６５０００５６９０１ＫＤＡＴ００
12 x 1.25 mm
65 N·m
(6.5 kgf·m, 48 lbf·ft)
8 x 1.25 mm
9 N·m (0.9 kgf·m, 7 lbf·ft)
B
C
(cont'd)
4-11
＊０３
＊０４