Troubleshooting - Meaco MeacoFan 650 Instruction Manual

TROUBLE SHOOTING
----------------------------------------------------------------------------------------------------------------------------- ----------
TROUBLE
The display shows '00' or
'99'
The fan does not oscillate
Increased noise level
The motor can be heard on
the lower fan speeds
The fan does not start up
The fan is making a clicking
noise
The remote does not work
AI appears on the display
CAUSE
There is a problem with the
circuit
The MPCB needs resetting
The fan blades are dirty
The fan blades or fan motor is
loose
There is a fault with the fan
motor
As the fan is so quiet it is
expected to hear the motor on
the lower fan speeds. As the
fan speed increases, the noise
of the motor will reduce
The fan is in standby mode
The fan needs lubricating
The battery needs replacing
The remote is being used more
than 3m away from the fan
This is a not a fault, the fan is
in ECO mode
SOLUTION
Please contact Meaco
Unplug the fan from the mains
for 40 minutes
Clean the fan blades (see page
9)
Tighten the locking cap (see
page 9)
Please contact Meaco
This is not a fault and is normal
Press the power button again
Run the fan on the highest fan
speed for 4 hours
Replace the battery (see page
10)
Use the remote closer to the
fan and make sure it is pointing
directly at the fan base
Press the ECO button to turn
ECO mode off
11