Advertisement
A S S E M B LY I N S T R U C T I O N S
New England Decorative Mounting Post
The New England Decorative
Mounting Post is designed to
showcase a variety of outdoor fixtures
such as bird houses, bird feeders, solar
lights, etc. (purchased separately).
The true 4"x4" vinyl post design will
provide support for outdoor fixtures
with a 4"x4" mounting base/cap (not
included in this kit). Please confirm
that your outdoor fixture has a 4"x4"
mounting base/cap intended to fit
over a true 4"x4" post.
Please read through before starting installation.
Check Box for These Contents
In the event of missing or defective parts please call our customer service department at 1 800 282 9346 (Mon. to Fri. 8:00 AM to 4:00 PM EST).
1.
Post (1) 4" x 4" x 60" - 10000
2.
Post Trim Cap (1) 10737-1
3.
Anchor Assembly (1) 11102
4.
Base Molding Cap (1) 10086
5.
Base Molding Post (1) 10145
6.
Base Molding Base (1) 10088
7.
1 1/2" Self-Augering Stainless Steel Screws (4) 20005
8.
Vinyl Glue (1) 20000
Tools You Will Need
· Sledge Hammer (5 or 10 lbs)
· Cordless Drill with Phillips Bit
· Spirit Level
· Adjustable Wrench
· Tape Measure
7
8
4 in
60 in
24 1/8 in
8 1/4 in
5 in
24 in
1
2
3
4
5
6
V1.2/011817
Advertisement
Table of Contents
Related Manuals for New England Arbors New England Decorative Mounting Post
Summary of Contents for New England Arbors New England Decorative Mounting Post
- Page 1 A S S E M B LY I N S T R U C T I O N S New England Decorative Mounting Post The New England Decorative Mounting Post is designed to showcase a variety of outdoor fixtures 4 in such as bird houses, bird feeders, solar lights, etc.
- Page 2 Run another bead of glue on the other (inside) end of the base molding post. Carefully place the base molding cap on the base molding post. Note: Please allow the glue to set for 15 minutes prior to installing the assembled base molding on the post. New England Decorative Mounting Post...
- Page 3 Reinstall the top outer donut. If the pipe is off-level, remove and adjust the position of the top and/or bottom donut to compensate for the crooked pipe. New England Decorative Mounting Post...
- Page 4 Slide the post trim cap upwards until the desired height is reached (±12 in from the top). Hold the trim cap in place until the glue sets. Insert the base mold over the bottom of the post as shown. New England Decorative Mounting Post...
- Page 5 Attach your outdoor fixture (purchased separately) to the top of the 4 in. x 4 in. post, following the instruction provided by the outdoor fixture manufacturer. A true 4 in. x 4 in. inside dimensions would be needed. New England Decorative Mounting Post...
Need help?
Do you have a question about the New England Decorative Mounting Post and is the answer not in the manual?
Questions and answers