Sony CCP-8000 Installation Manual page 49

Connecting procedure
1. Remove the module cover. Remove the screws (BV3
x 10) fixing the caps (L) and (R), and remove the caps
in the direction of the arrow.
2. Loosen the four screws (with drop-safe) fixing the
operation module.
3. Hold the two screws (with drop-safe) in the front of
the both sides of the operation module, and remove the
operation module.
Module covers
Cap (L)
BV3 x 10
Scrwes
(with drop-safe)
Operation module
4. Remove the screws (BV3 x 10) fixing the side plates
to the adaptor case, and remove the side plates.
BV3 x 10
Adaptor case
CCP-8000 IM
Scrwes
(with drop-safe)
BV3 x 10
Cap (R)
Side plates
BV3 x 10
2-5. Connecting the MKS-8075/MKS-8076
When the Vertical connection is selected
(1) Connect the adaptor cases together.
(Be careful of the direction of the adaptor cases. See the
instruction given on the bottom of the adaptor case.)
(2) Fix the right sides and left sides of the adaptor cases as
shown in the illustration using the two pieces of the con-
necting plate C.
. When fixing the adaptor cases, you can select either the
flat connection or the connection like a flight of steps.
. When selecting the connection like steps of the
connection method (A), (see Fig. 2) the two screws
are secured with one notch offset each other.
. When the flat connection method (B, C) is selected,
(see Fig. 2) the two screws are secured in the same
height.
Adaptor cases
Connecting
plate C
BV 3 x 10
When the Horizontal connection is selected
(1) Connect the adaptor cases together.
(Be careful of the direction of the adaptor cases. See the
instruction given on the bottom of the adaptor case.)
(2) Fix the top plate of the adaptor cases at the locations
shown in the illustration using the two connecting
screws and the two connecting plates A for every two
adaptor cases.
BV3 x 10
Instruction given on the
bottom of the cases
Instruction given on
the bottom of the case
Connecting
BV 3 x 10
plate C
BV3 x 10
Connecting plates A
Adaptor cases
2-9