Analysis Based On The Errors - Basic - Tanda AQUATOP Installation Manual

21. Analysis based on the errors - Basic

ERROR
RU N TIME
STOP ENGAGED
LEVEL 1
OVER CURRENT
NO PULSES
TEMP
NO CURRENT
POSITIONS
ERROR
ENCODER
LOCK
MAN-AT-E4
EXPLANATION
-THE MAXIMUM RUN TIME OF THE
MOTOR IS EXCEEDED.
-STANDARD SETTING = 10 MIN.
-CAN BE CHANGED VIA MENU I/O
SETUP – RUNTIME (AFTER CONTACT
WITH YOUR DEALER)
-KEY SWITCH IS ON "0"
-WATER LEVEL IS NOT OK
(IN CASE OF LEVEL SENSOR)
-MOTOR IS T00 WARM (IF SK-SK OF THE
MOTOR IS CONNECTED ON 10-11)
-MAXIMUM POWER OF THE MOTOR IS
EXCEEDED.
-THE CIRCUIT BOARD DOES NOT
RECEIVE PULSES FROM THE ENCODER
-THE MOTOR DOES NOT RUN.
-MAXIMUM TEMPERATURE OF THE
PRINT IS EXCEEDED.
-MOTOR DOESN'T RUN AND PULLS NO
CURRENT
-RUNNING DIRECTION OF MOTOR
DOESN'T CORRESPOND WITH
PROGRAMMED END POSITIONS
THE SETTED VALUE OF
MENU/PROT.LOCK EXCEEDED
LOCKS NOT OPEN (MANUAL OR
AUTOMATIC)
Manual Aquatop (2019)
ACTION
WAIT 10 MINUTES – RESET THE ERROR
BY TURNING THE KEY ON "0" AND
THEN BACK ON "1"
TURN THE KEY ON "1"
IF NOT SOLVED: CONTACT YOUR
DEALER
CHECK WATER LEVEL AND RESET THE
ERROR BY TURNING THE KEY ON "0"
AND THEN BACK TO "1". WHEN NO
LEVEL SWITCH IS CONNECTED
MOTOR IS WARM, WAIT FOR ONE
HOUR.
IF NOT SOLVED: CONTACT YOUR
DEALER
CHECK IF THE COVER IS NOT
BLOCKED, IN CASE EVERYTHING IS OK,
RESET THE ERROR BY TURNING THE
KEY ON "0" AND THEN BACK TO "1"
IN CASE THE ROLL CAN MOVE , THERE
MIGHT BE A DEFECT: CONTACT YOUR
DEALER
CONTACT YOUR DEALER
WAIT 20 MINUTES – RESET THE ERROR
BY TURNING THE KEY ON "0" AND
THEN BACK TO "1"
WHEN THE ERROR KEEPS COMING
BACK THERE MIGHT BE A PROBLEM
WITH THE PRINT IN THIS CASE
CONTACT YOUR DEALER
CONTACT YOUR DEALER
CONTACT YOUR DEALER
CHECK THE SITUATION OF THE LOCKS;
OPEN THE LOCKS – RESET THE ERROR
AND TRY AGAIN
IF PROBLEM RETURNS? CONTACT
YOUR DEALER
30