Remote Control - Tanda AQUATOP Installation Manual

5. Remote control

General
• The remote control gives you the comfort of operating the cover from a distance.
• The control box will therefore be extended with a relay card with 4 outputs.
• Together with the relay card(s) you can use the remote control for e.g. driving the
following equipment from a distance:
o Swimming pool light
o Garden light
o Jetstream
PLEASE NOTE: The maximum current intensity of the relay with 230Vac is 16A!
Never drive pumps and/or motors via this relay because of the starting power. Always
install extra power contactors.
•
The relays are potential free contacts.
Remark:
With a hydraulic drive relay No. 1 and 2 are not available as they are driving the pump group.
Installation:
• STEP 1: Put the receiver print on "Remote 1".
• STEP 2: Make the additional connection between the receiver print and the circuit
board using a data cable.
• STEP 3: Place the relay card and connect it with "Relay 1" on the circuit board (This
is the lower connection).
• STEP 4: Test the remote control with the sender. If necessary you can replace the
white wire with the supplied external antenna.
• STEP 5: (Only necessary in case of a replacement or additional sender or receiver) Set
the sender and the receiver (see Extra: (Programming sender/receiver)).
MAN-AT-E4 Manual Aquatop (2019) 8