Craftsman 65018 Assembly Instructions Manual page 14

Shed Assembly – Walls/
10
D
Tip left front corner (D) back to vertical position and
align lower tabs on right side with slots in floor.
12
Align tabs on bottom right side of left back corner (F)
with slots along rear floor. Lower panel into slots and
lock in place by sliding panel toward corner. Note: Use
a rubber mallet to "push" left back corner (F) into
locked position.
Continued
2
F
1
11
Before proceeding, make sure
corner is square (top view) where it
meets the floor and that panel is flush
(side view) with floor.
If not, repeat Steps 8-10
until square and flush.
Top view Top view
13
Tip left back corner (F) outward slightly and bend corner
hinge.
14
Side view Side view
D
F
2 2