Panasonic ECONAVI NA-FS20V5SRY Operating & Installation Instructions Manual page 7

3
Reserve function
You can select the finish time of a cycle
2–24 hours from the current time.
After performing Step 2 on page 6,
press the [Preset] key and select the
finish time (hours).
● The time is shown in the display area.
● The time increases by an hour each time you
press the key.
■ Check the set details
Press the [Preset] key when using the
reserve function.
● Settings of cycle, wash/rinse/spin, water level
and completion time display.
■ Cancel/change reserve function
Press "on / off" key to power off the
washing machine and repeat from
step 1 given in page 6.
Note
● Indicator of reserve, water level, ECONAVI
lights up for 2 minutes, only the reserve
indicator remains on afterwards.
● Do not use soap powder or strip.
● The finish time can exceed the programed
time due to the water feeding and draining
condition.
● This function is not available for all cycles.
(P.8)
1
Operation panel
About display area
Press "Super Dry" key and the
Super Dry (min) supper drying time displays.
(P.18)
Preset Press "Preset" key and the
(number of hours cleaning completion time displays.
later) (See left hand side for reference)
Time Display remaining time in minutes
(time in minutes) during operation.
The water level is displayed when
L
a cycle starts. (P.19)
Note
● "2H" displays in case remaining time is greater
than 99 minutes, "3H" display incase remaining
time is greater than 180 minutes and so forth.
Custom settings
You may change settings of wash/rinse/spin and
water level.
Set the water temperature for main wash
fill
Water temperature
Super soak: Approx. 40 °C
Hygiene: Approx. 60 °C
Wash: Approx. 40 °C
Water warm up: Approx. 30 °C
Selecting "Hot" or "Warm" water temperature,
stain will be cleaned easier.
After performing Step 2 on page 6, press the
"Stain Master +" button repeatedly until the lamp
of the desired water temperature lights up.
■ Set up wash/rinse/spin cycle
Run steps 1-2 on page 6, then press
"wash", "rinse", and "spin" key until
indicator of desired cycle lights up
respectively.
● Change settings of wash/rinse/spin
cycle after laundering started
Press "Start / Pause" key to pause cycle
operation, change settings, and press
"Start / Pause" key to resume operation.
■ Set up water level
Run steps 1-3 on page 6, then press
"Water level" key until indicator of
desired water level lights up respectively.
Note
● This setting is not available for all cycles. (P.8)
7