Cycle Guide (continued)
ECONAVI
The washing machine detects weight and water temperature of cloths and determines water level and
time for washing in "Normal" or "Soak" cycle.
Indicator description
Flashing: the indicator flashes from the beginning of cloth
weight detection to the end of ECONAVI determination.
Lights on: the ECONAVI energy saving cycle is running.
After the energy saving cycle is determined applicable,
the indicator stays on until end of the cycle.
Lights off: the ECONAVI energy saving cycle is not
running. The ECONAVI energy saving cycle is not running
due to poor conditions.
●
Cycle setting will be memorized after laundering operation only for cycles of Normal, Speedy, Delicate, Baby
care.
●
Each cycle may set up water level automatically or according to desired washing methods. (P. 7)
●
Water feeding and draining time is included in time requirements. This time may vary with water pressure,
draining condition, and weight of cloths.
●
Amount of foam may vary with load. For load greater than 7 k g (water level at 70 L) foam generated by
churning may appear less than expected. This is normal.
"Tub hygiene" cycle (P.22)
■ About switching cycles
You cannot change cycle after pressing the "Start" key. To change cycle, Turn off and on the
washing machine once, then set up new cycle.
●
Wash stages: load detection → Refill → wash → replenish water →wash
●
Rinse stages: draining →intermittent spinning → spinning → braking → cascade rinse
( Refill + intermittent Spinning → Spinning → Braking ) twice → Refill → rinse
●
Spin stages: draining → intermittent spinning → spinning → braking
Beeps after washing cycle ended
The washing machine beeps after washing cycle ended. You may disable this "cycle
ends" beeping.
■ To enable/disable the "cycle ends" beeping
In power off status:
Press and hold both "Start/Pause" and "On / Off" key at the same time for at least 6
seconds.
You will hear two short beeps after the "cycle ends" beeping is disabled.
You will hear two short beeps twice after the "cycle ends" beeping is enabled.
Note
●
The ECONAVI energy saving cycle may
not run due to conditions given below:
– There is water left in the washing
machine tub before any operation cycle
starts.
– A custom wash, rinse, or spin cycle is
selected.
The washing cycle remains intact when
the ECONAVI function is unavailable.
13