Medline MDS80500 Quick Start Manual

I.V. STAND, 4 HOOK WITH CAST IRON BASE
Top Pole
Bottom Pole
(5) Pre-assembled
Non - Locking Casters
MDS80500 (GPI075)
Revision: 01/18/16
Not Made with Natural Rubber Latex.
I.V. Hook

ASSEMBLY INSTRUCTIONS:

1. The one piece pole has two threaded ends
2. Lay the pole on the ground. Place the base
Locking Collar
3. Screw the I.V. hook unit onto the shorter
4. Adjust the height of the pole by loosening
5. Periodically check that the thread bolt is
6. Cleaning of the I.V. Stand should be in
Base
connected with a locking collar.
with the pre-assembled casters on its side
next to the pole. Secure the longer bottom
portion of the pole through the hole in the
base. Insert the flat washer first and then
the lock washer. Screw the nut into place.
Securely tighten the threaded nut with a
wrench.
threaded top portion of the pole.
and then tightening the collar firmly by
hand.
properly tightened in the bottom of the
base and that the nuts on the casters
are secure. Ensure the I.V. Hook is tightly
secured.
accordance with the facility's maintenance
policies.
MDS80500
Flat Washer
Lock Washer
Threaded Bolt