Advertisement
Quick Links
Installing the Body Fan on a SUNSTAR ZX32
Before beginning this procedure... If your bench has three support rails under the bench acrylic, read this sheet.
If your bench has four rails, read the other sheet. You will need a #2 Phillips screwdriver to perform this procedure.
In this kit you should find the following parts:
(4) - #10 x 1/2" Phillips pan head
sheet metal screws
(2) - 1/4-20 x 1/2" Phillips pan head
machine screws with lock washer
Body Fan
Body Fan
Endcap
Body Fan
Mounting Bracket
2
Slip the Body Fan into the Body Fan
Endcap, as shown. Be sure to insert
the wire connector into the rectangular
hole and route the wire in the groove
in the Body Fan Bracket.
(With 3 Support Rails)
WARNING
Shock hazard.
Be sure AC power is not connected
before performing this procedure.
1
Open the bench acrylic shield and
remove the Foot End Bench Endcap
by removing the four screws that
hold it in place. Save these screws
to install the new endcap.
3
Place the Body Fan Mounting
Bracket behind the Body Fan
Bracket and secure with the
(2) 1/4-20 x 1/2" screws.
SUPPORT RAILS
(under acrylic)
pg. 1
24735-02A
Advertisement
Related Manuals for SunStar ZX32
Summary of Contents for SunStar ZX32
- Page 1 Installing the Body Fan on a SUNSTAR ZX32 (With 3 Support Rails) SUPPORT RAILS (under acrylic) Before beginning this procedure... If your bench has three support rails under the bench acrylic, read this sheet. If your bench has four rails, read the other sheet. You will need a #2 Phillips screwdriver to perform this procedure.
- Page 2 Connect the Body Fan power cord to the cord coming out of the end of the bench. Using the screws removed from the old endcap, attach the new endcap to the bed. Start all four screws in their holes before tightening. Tighten the screws. Working from the inside of the bench, fasten the Body Fan Mounting Bracket to the metal endcap with the...
- Page 3 Installing the Body Fan on a SUNSTAR ZX32 (With 4 Support Rails) SUPPORT RAILS (under acrylic) Before beginning this procedure... If your bench has four support rails under the bench acrylic, read this sheet. If your bench has three rails, read the other sheet. You will need a #2 Phillips screwdriver to perform this procedure.
- Page 4 Holding the Endcap and Body Fan together, connect the Body Fan power cord to the cord coming out of the end of the bench. Then, pull the Body Fan almost out of the endcap as you put the endcap in place and drop the Body Fan into the Body Fan Mounting Bracket.
Need help?
Do you have a question about the ZX32 and is the answer not in the manual?
Questions and answers