Reversing The Door Swing - Kenwood KNFD2MT18 Installation Instructions Manual

installation ™ —
reversing the door sv\/ing
tools required: Philips style screwdriver / Flat bladed screwdriver / Hexagonal spanner
A • Ensure the unit is unplugged and empty.
• To take the door off it is necessary to tilt the unit backwards. You should rest the unit
on something solid, e.g. a chair just below the top panel.
• All parts removed must be saved to do the reinslallation of the door.
• Do not lay the unit flat as this may damage the coolant system.
• We recommend that 2 people handle the unit during assembly.
• If you want to have the door swing reversed, we recommend that you contact a
qualified technician. You should only try to reverse the door yourself if you believe that
you are qualified to do so.
1. Remove the upper hinge cover, screws
and upper hinge. Lift the upper door and
place it on a padded surface to prevent
from being scratched. Remove the screw
hole cover from the opposite side and keep
it for future use. For the right side, use the
screw hole cover from the plastic bag.
After lifting the hinge cover, be sure to
disconnect electrical connectors before
fully removing the hinge cover.
Screw hole cover has left and right
side. The screw hole cover packed
as an accessory Is for the right side.
Tt 4
2. Remove the upper door corner cover from
both the left and right side of the upper
door. Take out the magnet from the right
side. Then swap position between the
corner cover of the left side with the corner
cover and magnet of the right side.