Filling The Water Tank; Receiving Water From The Water Dispenser; Noises Inside The Unit - Kenwood KNFD2MT18 Installation Instructions Manual

filling the water tank
Open the small tank cover. Fill drinking water into the water
tank through the hole. Close the cover after filling.
A
Do not fill above the level, othenA/ise, it may
overflow.
Before filling with water, ensure that the water tank
is steady and in a correct position.
Apart from drinking water, other beverages (such
as milk, juice, carbonated beverage, etc) are not
suggested to be used, especially beverages that
include grain must not be used (may result in
blockage and damage).
Hot water must not be filled into the water tank
directly.
Do not touch other parts of the unit when filling
water, it may iead to leakage.
receiving water from the water dispenser
• You should use the type of container that can fit
under the water dispenser. Place the container
properly underneath and push on the lever for water
to flow.
noises inside the unit!
You may notice that your unit makes some unusual noises. Most of these are perfectly normal, but
you should be aware of them!
These noises are caused by the circulation of the refrigerant liquid in the cooling system. It has
become more pronounced since the introduction of CFC free gases. This is not a fault and will
not affect the performance of your unit. This is the compressor motor working, as it pumps the
refrigerant around the system.
18