Troubleshooting; Malfunctions During Operation - Geberit AquaClean 4000 User Manual

User manual Geberit AquaClean 4000

Troubleshooting

DANGER
Danger of fatal electric shock
Never open and repair the device yourself
Never replace damaged mains connection cables yourself
Contact customer service

Malfunctions during operation

Malfunction Malfunction
Malfunction Malfunction
No function
Shower water temperature is
too low
Shower spray is too weak or
no water is spraying out at all
Spray arm does not retract
Lowering function not
working
Water runs out of the
overflow on the left next to
the spray arm
14
Cause Cause
Cause Cause
Mains plug is not connected to
power outlet
Defective fuse on electrical
distributor
Fuse in mains connection cable
is defective
Power supply is interrupted
Heating element is not switched
on
Warm-up time too short when
heating element is in economy
mode
Spray intensity is set too low
Spray nozzle clogged or blocked
with limescale
Basket filter is clogged or
blocked with limescale
Power supply is interrupted
Enhancement solution is
defective
Hydraulics are defective
Fault clearance Fault clearance
Fault clearance Fault clearance
Connect the mains plug
Replace the fuse on the electrical
distributor
Disconnect the mains plug and
contact customer service
Have the power supply checked
by a skilled person
Set the <water heater function>
to ON on the control panel
Set the <water heater function>
to ON on the control panel
Increase the spray intensity
Clean or replace the spray nozzle
Clean or replace the basket filter
Restore the power supply. The
spray arm will retract
automatically
Switch off the enhancement
solution and contact customer
service
Contact customer service
Disconnect the mains plug, close
the angle stop valve, and contact
customer service