Setup; Installing The Handle; Checking The Engine-Oil Level; Checking The Eccentric-Oil Level - Toro FP-2200 Operator's Manual

Setup

Installing the Handle

Secure each side of the handle to the plate compactor
frame using a bolt, flat washer, spacer, bearing, and
locknut (Figure 3 or Figure
Model 2200
1. Locknut
2. Bearing
3. Handle
4).
Figure 3
4. Spacer
5. Flat washer
6. Bolt
1. Locknut
2. Bearing
g019697
3. Handle
Checking the Engine-Oil
Level
The machine comes from the factory with oil in the
engine crankcase; however, it may be necessary to
add oil; refer to
7). Add only enough oil to raise the level to the Full
mark on the dipstick.
Checking the Eccentric-Oil
Level
The machine comes from the factory with eccentric oil
in the eccentric housing; however, it may be necessary
to add oil; refer to
17). Add only enough oil so that the oil level is flush
with the oil plug on the side of the eccentric housing.
6
Figure 4
Model 3000/4000
4. Spacer
5. Flat washer
6. Bolt
Checking the Engine-Oil Level (page
Servicing the Eccentric Oil (page
g027147