Shut Down The Array Using The Cli; Restart The Array; Array Leds - Hewlett Packard Enterprise AF20 Hardware Manual

Shut Down the Array Using the CLI

Shut Down the Array Using the CLI
This action shuts down the array and any expansion shelves managed by the array.
For most hardware changes you do not need to shut down (power off) the array because the components
are redundant and hot swappable.
Caution When you shut down the array, all volumes go offline.
Procedure
1 Determine the name of the array.
array --list
The name of the array appears in the list.
2 Halt the array.
halt --array array_name
Example
Nimble OS $ halt --array datamaster-a

Restart the Array

You rarely need to restart an array.
You must use the CLI to restart the array. Any expansion shelves managed by the array also restart.
Caution When you restart the array, all volumes temporarily go offline.
Procedure
1 Determine the name of the array.
array --list
The name of the array appears in the list.
2 Reboot the array.
reboot --array array name
Example
reboot --array datamaster-a

Array LEDs

The array front LEDs are located on both handles. The power button and power supply status LED are only
on the right handle.
©
Copyright 2020 by Hewlett Packard Enterprise Development LP. All rights reserved.
Documentation Feedback: doc-feedback-hpe-nimble@hpe.com
45