Troubleshooting - Meaco 12L Low Energy Instruction Manual

TROUBLE SHOOTING
----------------------------------------------------------------------------------------------------------------------------- ----------
TROUBLE
Unit does not operate
Unit does not dehumidify or
collects little water
The dehumidifier works but
reduces the relative humidity
insufficiently/there is little
water in the water tank
CAUSE
There is no power to the unit.
The ON/OFF button has not
been pressed.
Ambient temperature is lower
than +5°C (C2 appears on the
display and you will hear 3 long
bleeps and 2 short bleeps).
Ambient temperature exceeds
35°C (C2 appears on the
display and you will hear 3 long
bleeps and 2 short bleeps).
The ambient air humidity is
lower than 45%rh.
The air filter is dirty and
blocked.
The actual humidity is below
the target humidity set point.
The unit is in Air Purification
(AP mode).
The house is too large. This
dehumidifier can dry up to
about a three/five bedroom
house (12/20L).
There are too many sources of
moisture. Bathing, washing,
drying clothes and cooking all
add moisture to the air. Bottled
gas heating can add too much
moisture into the air for a
dehumidifier.
SOLUTION
Plug in the unit and check the
power outlet.
Press the ON/OFF button.
Under this condition the
dehumidifier becomes
inefficient. It is recommended
to switch off the dehumidifier.
Under this condition the
compressor is overloaded and
switches off automatically. It is
recommended to switch off the
dehumidifier.
Under this condition the
dehumidifier becomes
inefficient and little water will
be collected.
The air filter must be cleaned.
If the air filter is beyond
cleaning, it must be replaced.
This is normal and is not a
fault.
Use the arrows to change the
dehumidifier into another
mode.
We recommend using a
dehumidifier with a greater
capacity.
We recommend using a
dehumidifier with a greater
capacity. Consider using a
different heat source to a
bottled gas heater.
18