Controlling Audio; 3-Way Speaker System Setup - Kenwood DDX9907XR Instruction Manual

Controlling Audio

You can adjust various settings such as audio
balance or subwoofer level.
1
Press the [MENU] button.
h Popup menu appears.
h
2
Touch [Audio].
See the following section for each
setting.
• Set up Speaker / X'over (P.88)
• Controlling EQ / SW Level (P.90)
• Set Position / DTA (P.94)
• Controlling Fader / Balance (P.90)
• Set Volume Offset (P.91)
• Performing Zone Control (P.92)
• Set Sound Effect (P.93)
• Use Audio Memory (P.95)

3-way speaker system setup

(DDX9907XR / DMX957XR /
DMX907S)
Select the appropriate crossover network
mode for the speaker system used (2-way or
3-way speaker system).
1
Press the [HOME] button.
h HOME screen appears. h
2
Touch [
].
h Source selection screen appears.
h
3
Touch [STANDBY].
4
Press the button 1 followed by the
button 2 for 1 second at the same time.
DDX9907XR
2
DMX957XR / DMX907S
1
h Speaker system select screen appears.
h
5
Select the crossover network mode.
h A confirmation screen appears.
h
6
Touch [Yes].
NOTE
• When the 3-way speaker system is selected, the
following functions are disabled.
– Front focus of Listening Position / DTA
– Fader for Controlling General Audio
– Zone Control
– Selection of the speakers to output sound from
the cell-phone of Bluetooth HF/Audio
– Beep for User Interface Setup
• Connecting 3-way speakers with the 2-way mode
selected can break the speakers.
• When the dual zone is selected and audio source
other than "OFF" is selected as Rear Source, the
speaker system cannot be switched.
Controlling Audio
1
2
87
English