Cleaning The Tubing - Medela Freestyle Flex Instructions For Use Manual

5.6 Cleaning the tubing

Normally, cleaning of the tubing is not necessary. Only if it is dirty or if milk is present it is
necessary to wash the tubing as described in these instructions.
Supplies needed:
• Drinking-quality water
• Mild dish soap
NOTICE
• If the tubing becomes mouldy, discontinue use and replace tubing. Refer to chapter 14 for
ordering information.
• Do not use the breast pump with wet tubing; doing so will cause damage to your breast
pump.
i
Information
• Wash the tubing only if it is dirty or if milk is present.
• It is not necessary to clean the tubing if there is condensation forming inside from previous
washings or atmospheric conditions.
In this case, just follow the instructions for drying.
Washing the tubing
Drying the tubing
1. Shake out any water droplets.
2. Hang the tubing to air dry.
3. Make sure that the tubing is completely dry before using it.
Parts needed:
• Tubing
1. Switch the breast pump off.
2. Remove the tubing from the motor unit.
3. Remove the tubing from the connector cap.
4. Rinse the tubing by pouring cool water into both short
tubing ends until it flows out of the long tubing end.
5. Wash the tubing in warm, soapy water.
6. Rinse the tubing with clear water.
19