Advertisement
For Tower Type
（１ｋＶＡ）
① Remove by sliding in the
direction of the arrow by
holding two places of
strongly.
●
（2ｋＶＡ / 3ｋＶＡ）
① Remove by sliding in
the direction of the arrow
by holding two places of
strongly.
⑥ Remove the tape from the battery connector on the new battery pack and attached it to the used battery pack connector.
⑦ Insert the new battery pack into the UPS.
⑧ Plug in the battery connector.
② Loosen the screw and slide
the battery cover in the
direction of the arrow. The
screw is a fall prevention
screw, so it can't come off
the battery cover.
For service personnel only
Slide the switch to
③
｢Bypass｣
② Loose the screw, slide the battery cover
up, and pull forward.
5
For service personnel only
Slide the switch to
③
｢Bypass｣
pack out.
⑤
Disconnect the battery conn
ector.
④
Attach the tape and insulate
it.
⑥
Pull out the battery pack out
⑤
Disconnect the battery
connector.
④
Attach the tape and
insulate it.
⑥
Pull out the battery
Advertisement
