GE PACSystems RXi Series Quick Start Manual page 7

7
Power On/Off Switch and Status Indicator Operation
Normal Operation Action
†
Press and hold the button for at least ½ second.
If powering up from a no-power state, the ring LED blinks blue while the IPC is booting and is solid green
Power up the IPC when the IPC is up and running.
If the system has been shut down, but power has not been cycled, the ring LED blinks blue for 40 seconds
before changing to solid green.
Press and hold the button briefly (between 100ms and 4 sec).
Shut down the IPC
The ring LED stays green while the IPC is shutting down, then turns off when the IPC is powered down.
The default BIOS settings when shipped from the factory are:
Sleep Mode
The default settings send IPC to sleep state S1.
The ring LED stays green while the IPC is in Sleep State S1.
The ring LED fades blue while the IPC is in Sleep State S3.
Caution: Use this option only if the operating system is non-responsive.
Forced Shut down Press the button for at least 4 seconds.
The ring LED turns off.
The ring LED displays solid red to indicate a fault, including overtemp condition.
†
IPC Status Indicators Operation
Indicator
SATA Drive Status
Overtemp
Ethernet Port LEDs Operation
Each Ethernet port has two LED indicators, ACTIVITY and LINK.
Enable Hibernation is disabled
•
• ACPI Sleep State is S1 (CPU Stop Clock)
State Description
White, blinking Read/write access on SATA drive
The IPC's internal temperature has exceeded the maximum allowable value.
Red, solid
To recover, let the IPC cool, then press the Power On/Off switch.
LED LED State
ACTIVITY
LINK
Operating State
Blinking, Green Traffic is detected at the port
On, Green Link is operational
PACSystems RXi IPC QSG
GFK-2784J