Sealey MS070.V2 Manual

thank you for purchasing a Sealey product. Manufactured to a high standard, this product will, if used according to these
instructions, and properly maintained, give you years of trouble free performance.
IMPORTANT: PLEASE READ THESE INSTRUCTIONS CAREFULLY. NOTE THE SAFE OPERATIONAL REQUIREMENTS, WARNINGS & CAUTIONS. USE
THE PRODUCT CORRECTLY AND WITH CARE FOR THE PURPOSE FOR WHICH IT IS INTENDED. FAILURE TO DO SO MAY CAUSE DAMAGE AND/OR
PERSONAL INJURY AND WILL INVALIDATE THE WARRANTY. KEEP THESE INSTRUCTIONS SAFE FOR FUTURE USE.
Warning
Refer to
laser beam
instructions
1. SAfety
WArning! ensure Health & Safety, local authority, and general workshop practice regulations are adhered to when using this
‰
equipment.
Maintain the wheel alignment tool in good condition.
9
Replace or repair damaged parts. Use genuine parts only. non-authorised parts may be dangerous and will invalidate the warranty.
9
locate wheel alignment tool in a suitable working area, keep area clean and tidy and free from unrelated materials.
9
WArning! ensure that the motorcycle is on a stable stand located on level and solid ground.
‰
Keep the gauge scales clean to ensure accurate performance.
9
Do not use outside in damp or wet weather conditions.
8
Do not allow untrained persons to operate the aligner.
8
WArning! The warnings, cautions and instructions contained within this document cannot cover all possible conditions and
‰
situations that may occur. It must be understood that common sense and caution are factors which cannot be built into this product,
but must be applied by the operator.
Any alignment changes deemed necessary as a result of using this equipment must be made strictly in accordance with the
9
motorcycle manufacturer's recommendations.
▲ laser Safety
The MS070 utilises a Class 2M laser that emits low levels of visible radiation light (i.e. wavelengths between 630 and 640 nanometres)
which are safe for the skin but not inherently safe for the eyes. The Class 2M emission limit is set at the maximum level for which eye
protection is normally afforded by natural aversion responses to bright light. Accidental eye exposure is therefore normally safe,
although the natural aversion response can be overridden by deliberately staring into the beam, and can also be influenced by the use
of alcohol or drugs.
WArning! Do not look or stare into the laser beam as permanent eye damage could result.
‰
Do not direct the laser beam at any person's (or animal's) eyes as eye damage could result. If the beam is obstructed by a person
8
during use, release the contact switch immediately.
Do not use the equipment while under the influence of alcohol, drugs or whilst on medication.
8
Be aware that reflections of the laser beam from mirrors or other shiny surfaces can be as hazardous as direct eye exposure.
9
2. introDuction
Fast, simple and accurate alignment of rear wheel. Optimises vehicle performance and set up after installation or modification of the chain,
sprockets, brakes or suspension components. This fully portable kit is also ideal for track-day set up or for the motorcycle enthusiast.
© Jack Sealey limited
Motorcycle Wheel AlignMent tool
MS070.V2
Model no:
Original Language Version MS070.V2 Issue 2 (H4F) 25/05/18