Chubbsafes Professional S2 User Manual
Electronic lock
For more information, please visit www.chubbsafes.com
Related Manuals for Chubbsafes Professional S2
Summary of Contents for Chubbsafes Professional S2
- Page 1 PROFESSIONAL S2 SAFE USER GUIDE ELECTRONIC LOCK USER GUIDE www.chubbsafes.com “Chubb” is owned by Chubb plc and is a registered trademark used under license...
- Page 2 General Description The lock is operated by a 6 digit PIN number; the lock can accept two individual user codes GREEN LED RED LED which are programmed separately – the PRIMARY and the USER codes. It is possible to set a time-delay feature whereby a set period of time (0 to 99 minutes) has to elapse between entering a valid opening code and it being possible to open the safe.
- Page 3 How to Open the Safe for the first time 1. Press “ON” – the buzzer signals once and the green LED light flashes 2. Enter the primary code upon delivery the default primary code is 1-2-3-4-5-6) 3. Press “ENTER”. 4. Both the buzzer sounds and the green LED flashes twice 5.
- Page 4 Programming the User Code (with the Primary Code) Upon delivery the User Code function is not activated; there is no default code. This allows the Primary code owner to set and control a second access number, the “user code”. The owner of the Primary code can disable the user code if required. Setting the User code means that the safe can be opened by two individuals using different codes.
- Page 5 Power Supply Control If battery power is running low, the buzzer and the red LED will signal five times after each keypad entry. The “ON” button must be pressed before it is possible to open the lock, and pressing “ENTER” to change codes is blocked. This operation is indicated by a single long buzzer and red LED remains lit.
- Page 6 Programming time delay Please note, operating the lock in time delay mode will adversely affect battery life. Open the safe with the Primary code Press “ON” the buzzer sounds and green LED flashes Press “ENTER” the buzzer sounds and green LED flashes ...
- Page 7 Cancelling the time delay function Open the safe with a valid code Press the “ON” button, buzzer will sound and green LED will flash Press the “ENTER” button, buzzer will sound and green LED will flash Press “6”, buzzer will sound and green LED will flash ...
- Page 8 Anchoring your safe The Professional S2 safe is supplied with anchors for floors with solid concrete bases. A minimum of 100mm depth is needed to correctly bolt down your safe. Take care to note the positions of any services or damp proof coarse which might be installed and avoid anchoring in these areas.
Need help?
Do you have a question about the Professional S2 and is the answer not in the manual?
Questions and answers