Removing The Filter Assembly - vollara AIR & SURFACEPRO Manual

UNINSTALLING THE OPTIONAL HEPA FILTER SHEET (CONTINUED)
1a. Remove the Filter Assembly (see
below).
1b.
Remove the HEPA Filter Sheet on
top of the Prefilter.

REMOVING THE FILTER ASSEMBLY

WARNING: Unplug the unit before performing any maintenance procedures .
WARNING: Do not operate the Vollara Air & Surface Pro without the Filter Assembly and back cover properly installed .
1 . Unplug unit .
4 . Press the tab down release
the Filter Assembly .
2. Replace the Filter Assembly,
inserting the bottom of the
Filter Assembly first.
2 . Press the top of the back cover
to release the back panel .
5 . Lift the Filter Assembly up
and out to remove .
3. Replace the back
cover by inserting the
bottom in first and
snapping into place.
3 . Lift up to remove the
back panel .
9