Led Status Displays For The Device State - Lenze L-force 9400 Series Software Manual

9400 regenerative power supply module | Parameter setting
Diagnostics & fault analysis
LED status displays
8.1.1

LED status displays for the device state

The states of the "DRIVE READY" and "DRIVE ERROR" LEDs in the middle of the regenerative
power supply module's front panel depend on the device
[8-2] LED status displays DRIVE READY and DRIVE ERROR
DRIVE READY
OFF
OFF
OFF
OFF
Legend
Meaning of the symbols used to represent the LED states:
188
DRIVE READY
DRIVE ERROR Meaning
OFF State "Initialisation active"
OFF State "Device is ready to switch on"
OFF State "Device is switched on"
OFF State "Operation"
State "Warning active"
The regenerative power supply module is ready to switch on,
switched on, or operation is enabled and a warning is indicated.
State "Trouble active"
State "Fault active"
State "System fault active"
LED flashes once for short time, approx. every three seconds (slow flash)
LED flashes twice for a short time, approx. every 1.25 seconds (double flash)
LED blinks every second
LED is lit permanently
L
state.Device states
DRIVE ERROR
or State "Warning locked active"
EDS94ARNExxxx EN 2.3 - 06/2014
( 79)