Care And Maintenance - Cosatto woosh xl Instruction

Footmuff 25-
(Sold separately)
Hood 26-
27-
28-
29-
Sun visor 30-
31-
Toy (not supplied) 32-
Hood 33-
Basket 34-
35-
Raincover 36-
37-
Drink holder 38-
Seat cover 39-
40-
Care & maintenance:
•
Your pushchair has been designed to meet comprehensive safety standards, and with correct use and
maintenance will give many years of trouble free performance.
•
Storage - Always store your pushchair dry. Storing a damp pushchair will encourage mildew to form,
so after exposure to damp conditions, dry off with a soft cloth and allow to dry thoroughly before
storing. Never leave in sunlight for prolonged periods - some fabrics may fade.
•
Cleaning - Refer to the wash care label on soft goods for cleaning instructions. Plastic and metal parts
may be sponged clean with warm water and a mild detergent. Never clean with abrasive, ammonia
based, bleach based or spirit type cleaners.
•
Wear & Tear - Continual impact will cause damage. The chassis is strong but will weaken should the
back wheel be bumped down stairs or kerbs. Tyres will wear with use and wheel units should be
replaced if necessary. If your child wears hard shoes these might damage the soft fabric.
•
Maintenance - Regularly inspect the locking devices, brakes, wheels, harness assembly, catches, seat
adjusters, joints and fixtures to ensure they are secure and in full working order. They should move
freely at all times and minimum maintenance should be required. However a regular light application
of a spray lubricant e.g. silicone (do not use oil or grease) will extend the life of your pushchair and
make opening and folding easier. Your pushchair should be serviced and reconditioned before using
it for a second baby, or after 18 months, whichever is the sooner.
Fitting:
18
Open the harness and remove the chest pads & crotch pad (a).
Push the harness straps through the footmuff (b).
Attach the footmuff flap over the rear of the backrest (c).
Refit chest pads & crotch pad then close the harness
Removing is a reversal of this procedure.
Opening:
Closing:
Using the viewing window flap:
Using the hood pocket:
Opening:
Closing:
Fitting:
Removing:
Refitting is a reversal of this procedure.
Accessing the basket from behind:
Removing:
Refitting is a reversal of this procedure.
Fitting:
Using access zip:
Fitting:
Removing:
Remove the harness (refer to step 24) & hood (refer to step 33) respectively.
Release the fabric fastener on the underside of the calf support (a).
Release the poppers under the seat (b).
Unfasten the fastening tabs on each side of the handle (c).
Unfasten the fabric fastener at the bottom of the seat (d).
Remove seat cover.
Refitting is a reversal of this procedure.
Prior to cleaning the seat cover, remove the seat (a) & backrest (b) boards.
Ensure that backrest board is in the correct orientation before refitting.
19
.
4