Electrical Wiring; General Precautions On Wiring - Panasonic PAW-160MAH2L Installation Instructions Manual

Air handling unit kit for panasonic ecoi; panasonic eco g; panasonic paci
Table of Contents

Advertisement

5

Electrical Wiring

5.1

General precautions on wiring

WARNING
Electric shock from live power supply cords
Electric shock may result from contact with live power supply cords.
► Wiring installation must only be performed by a qualifi ed electrician.
► Before starting to work on any machines or devices, always switch off the power sup-
ply and lock it in switched-off position.
CAUTION
The following precautions need to be followed strictly in the context of working on any
electrical wiring, in order to avoid hazardous situations, which could result in minor or
moderate injury.
► Before wiring, confi rm the rated voltage of the unit as shown on its nameplate, then
carry out the wiring closely following the wiring diagram.
► This equipment is not provided with a power supply cord. Circuit breaker must be
incorporated in the fi xed wiring in accordance with national wiring regulations. The
circuit breaker must be approved, suitable for the voltage and current ratings of equip-
ment and have a contact separation in all poles.
► To prevent possible hazards from insulation failure, the unit must be grounded.
► Each wiring connection must be done in accordance with the wiring system diagram.
Wrong wiring may cause the unit to misoperate or become damaged.
► Do not allow wiring to touch the refrigerant tubing, compressor, or any moving parts of
the fan.
► Unauthorized changes in the internal wiring can be very dangerous. The manufacturer
will accept no responsibility for any damage or misoperation that occurs as a result of
such unauthorized changes.
► Regulations on wire diameters diff er from locality to locality. For fi eld wiring rules, ple-
ase refer to the relevant local electrical codes before beginning.
You must ensure that installation complies with all relevant rules and regulations.
► To prevent malfunction of the air conditioner caused by electrical noise, care must be
taken when wiring as follows:
● The remote control wiring and the inter-unit control wiring should be wired
apart from the inter-unit power wiring.
● Use shielded wires for inter-unit control wiring (between units) and ground
the shield on both sides.
► If the power supply cord of this appliance is damaged, it must be replaced by a repair
shop designated by the manufacturer, because special-purpose tools are required.
Electrical Wiring
55

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents