Installing The Indoor Control Panel - Pentair EASYTOUCH PL4 Installation Manual

22

Installing the Indoor Control Panel

The ollowing procedure describes how to install the EasyTouch PL4/PSL4 Control Systems Indoor
Control Panel in to the Power Center. Read through the installation procedure before starting.
The PSL4 Control System Indoor Control panel provided one touch controls for your pool, spa, lights
and other functions from inside your home or a sheltered location. Select a convenient wall location
inside your the house or other weather-protected location for mounting the control panel.
Drill control panel wall mounting holes
To drill the control panel mounting holes (see diagram on next page):
1. The control panel is 5¾" wide. Using the cutout template shown below, mark the two screw
locations on the wall for the mounting holes. Drill the two mounting holes. If the screws are
not being screwed into studs, drill 3/16" holes and insert wall anchors as required.
2. Drill a 1 inch hole in the area shown in the template for the communication cable to feed
through.
Edge of Control Panel
3/16" Hole for Plastic Anchor
DRILL HOLE FOR
COMMUNICATION CABLE
HERE
3/16" Hole for Plastic Anchor
Edge of Control Panel