Fujitsu GW1500 Getting Started Manual page 44

GW1500 Getting Started Guide
Setting Relay Rules and Filter Rules
To enable the notification of the device information that is set in
for the Instruments Connected to the Device" on page 41
access from the center to the instruments that are connected to the device, it is necessary
to set the relay rules and the filter rules. Create the relay rules and filter rules as a CSV
file.
For details, refer to the "User's Manual".
Clearing the Setup Contents
If the device is set incorrectly or trouble occurs, you can use either of the following
methods to return the device to the factory default settings.
- Pressing and holding the INIT switch on the base surface of the device
- Executing the reset clear command
Attention!
If the device is returned to the factory default settings, all of the contents set up
until that point will be lost. We recommend that you save the configuration
definition information.
For details on saving configuration definition information, refer to the "User's
Manual".
● Pressing and holding the INIT switch on the base surface of the device
You can reset the device settings to the factory default by pressing and holding the INIT
switch on the base surface of the device (for about two seconds).
<View from the Rear>
Reset Switch
(INIT)
● Executing the reset clear command
You can reset the device settings to the factory default by executing the reset clear
command.
# reset clear
via the device, or to enable
44
"3.5.5 Setting Information
Chapter 3 Device Settings