Table of Contents
Advertisement
GW1500 Getting Started Guide
3.5.2
Setting Device Specific Information (ID/
Password)
Set device specific information using the following commands:
- Setting the ID for the device (sgw id command)
- Setting the password for the device (sgw password command)
[Setting Procedure]
1.
Execute the configure command to move to the configuration definition mode.
# configure
2.
Execute the sgw id command and set the device ID (FENICS-ID).
# configure
(config)#
(config)# sgw id xxxx
3.
Execute the sgw password command and set the password for the device
FENICS-ID.
(config)# sgw password yyyy
Set the ID and password that are specified for the FENICS II M2M service.
This is used in verifying communication with the center (initial communication,
Tips
periodic communication, FTP, SSL-VPN connection).
3.5.3
Setting the License Information
This is necessary only when you purchase an optional instrument
management license. If you do not purchase an instrument management
Tips
license, proceed to
In the initial state, up to 10 instruments can be connected to the device. If you want to
increase the number of connected instrument, purchase of an optional instrument
management license is required. There are three types of instrument management
licenses.
Instrument management 10 license: 10 additional instruments can be connected to the
device.
Instrument management 50 license: 50 additional instruments can be connected to the
device.
Instrument management 100 license: 100 additional instruments can be connected to the
device.
"3.5.4 Setting the Device IP Address" on page
39
40.
Chapter 3 Device Settings
Advertisement
Table of Contents
